Knowledge is no fun, unless you share it!!! :)

Friday, 6 December 2013

Transaction in SQL SERVER:

Transaction is very interesting topic, i have came across ever.It is very necessary for maintaining integrity of database.

So let’s see some interesting facts about transactions.

A transaction is a unit of work that is performed against a database. Transactions are units or sequences of work accomplished in a logical order, whether in a manual fashion by a user or automatically by some sort of a database program.
For example, if you are creating a record or updating a record or deleting a record from the table, then you are performing transaction on the table. It is important to control transactions to ensure data integrity and to handle database errors.
Practically, you will club many SQL queries into a group and you will execute all of them together as a part of a transaction.

Properties of Transactions:

Transactions have the following four standard properties, usually referred to by the acronym ACID:
Atomicity: ensures that all operations within the work unit are completed successfully; otherwise, the transaction is aborted at the point of failure, and previous operations are rolled back to their former state.
Consistency: ensures that the database properly changes states upon a successfully committed transaction.
Isolation: enables transactions to operate independently of and transparent to each other.
Durability: ensures that the result or effect of a committed transaction persists in case of a system failure.

Transaction Control:

There are following commands used to control transactions:
COMMIT: to save the changes.
ROLLBACK: to rollback the changes.
SAVEPOINT: creates points within groups of transactions in which to ROLLBACK
SET TRANSACTION: Places a name on a transaction.

Transactional control commands are only used with the DML commands INSERT, UPDATE and DELETE only. They can not be used while creating tables or dropping them because these operations are automatically committed in the database.

The COMMIT Command:

The COMMIT command is the transactional command used to save changes invoked by a transaction to the database.
The COMMIT command saves all transactions to the database since the last COMMIT or ROLLBACK command.

The syntax for COMMIT command is as follows:

The ROLLBACK Command:

The ROLLBACK command is the transactional command used to undo transactions that have not already been saved to the database.
The ROLLBACK command can only be used to undo transactions since the last COMMIT or ROLLBACK command was issued.

The syntax for ROLLBACK command is as follows:

The SAVEPOINT Command:

A SAVEPOINT is a point in a transaction when you can roll the transaction back to a certain point without rolling back the entire transaction.

The syntax for SAVEPOINT command is as follows:

This command serves only in the creation of a SAVEPOINT among transactional statements. The ROLLBACK command is used to undo a group of transactions.

The syntax for rolling back to a SAVEPOINT is as follows:


The RELEASE SAVEPOINT command is used to remove a SAVEPOINT that you have created.

The syntax for RELEASE SAVEPOINT is as follows:

Once a SAVEPOINT has been released, you can no longer use the ROLLBACK command to undo transactions performed since the SAVEPOINT.


The SET TRANSACTION command can be used to initiate a database transaction. This command is used to specify characteristics for the transaction that follows.

For example, you can specify a transaction to be read only, or read write.
The syntax for SET TRANSACTION is as follows:

Your comments and suggestions are appreciated....

Thanks..!!! :)

No comments:

Post a Comment